Mouse Bungee for Monitor.

thingiverse

Its essentially a cable holder that acts like a bungee, to keep your mouse cable tucked near a corner of the monitor and prevent it from getting in way or rubbing against the Monitor arm/stand. It has two channels that can fit both braided/ non braided mice wires. Adjust it accordingly, and use double sided tape inside the cavity to stick it to the Monitor panel. I would advise using a piece of painters tape to be stuck on the panel, and then the double sided tape on the painters tape, since the painters tape can be removed if needed without leaving residue behind on the panel. Print it standing upright with 2-3 perimeters, and if you can, try to change extrusion width to 0.5 mm since the clearances would fit better that way.