MP Select Mini Combo Cable Brace and Y Tensioner

thingiverse

I was replacing the Y axis belt and pulleys on my V2 and had decided to use No Drill Monoprice MP Select Mini GT2 Y Tensioner" by divide and get rid of the clothespin spring. However, I was already using Monoprice Mini cable brace remix" by Sk_2002 to route the cables from my bed rewire and it was in the way. So I did a Frankenstein and mashed them together into one piece. I also modded the stop to get rid of the paper clip. I built it and it mounts fine, but when I went to change the belt I found that the rails and bearings were toast and I was not able to find replacements, so I decided to install the Cheapus Maximus mod so I could use standard parts, so this project is no longer needed. Maybe someone else will have a need so here it is. Update: I ended up using this design and found an issue. The belt can slip thru the grip of the rear slide so I increased the length of the grip. I had problems the grip breaking off the rear slide so I reinforced the grip and recommend that it be printed standing on its end. I increased the grip and improved the mount of the front mount but on reflection, I think this part is not needed. I can see no advantage over using a zip strip like the factory. The belt radius slips into the belt hole and provides a smooth surface for the belt to pull over.