MPCNC Parallel Conduit Chain Support

thingiverse

I created these 3/4" EMT MPCNC Conduit adapters, which allow me to run parallel pipes along my X and Y axis while experimenting with cable chains that keep all wires and cables above the workable area. This setup provides a cleaner look and helps maintain a clean work surface. For maximum conduit support, I recommend printing four double corners, cutting new sets of x and y conduit pipes, then assembling them together. Running only one set of X and Y pipes creates an issue: one corner has to use the 'C' end and fit snugly, or the pipe on that side will sag. Take a look at the pictures for a better understanding. I welcome your comments and suggestions. Happy tinkering!