MPCNC Rotozip SCS-01 mount

thingiverse

Edit 11-15-17: I changed the top mount to use a fully split ring to make installation and removal easier. I needed a mount for an old RotoZip to attatch to a Mostly Printed CNC. This one may fit others. The lower mount of my Rotozip is 43mm, the upper is 67mm. I used the blank mount from Allted to get the hole pattern. The mounts are a bit thicker than needed so its quite difficult to install because I didnt want to have to worry about stiffness or it breaking. Also, I tend to make my holes a little tight and ream them out to exact dimensions, so the screw holes are a bit tight as well. I used some of the extra 6-32 hardware from building the MPCNC to clamp it onto the rotozip.