MTW Suppressor

thingiverse

It's a suppressor specifically designed for Wolverine Airsoft MTW. Fits inside the m-lok handguard. Hexagonal pattern on the outside. Note that you can't mount anything on the sides, or the lower 45° mlok holes. You want to mount a flashlight etc, it needs to go on the upper 45° holes. Grips etc on the bottom are fine. More volume means better suppression, and I didn't want to make the suppressor any longer, so the first chamber goes back around the barrel. The size is roughly 42mmx200mm. Use foam/scotch-brite/whatever on the inside. You can also add a layer of painters tape on the baffles and shoot a hole through. Keep in mind that this might affect accuracy, but its better for suppression. Depending on your printer, some parts might need some grinding to make a tight fit. There is an option for a M4 brass insert to secure the suppressor, but if you make it fit tight enough, it shouldn't be necessary. Correct orientation of the parts shown above, no supports needed. Use whatever material you like, I used eSun PA-CF. Parts list: End plate (Needs a tight fit around the barrel,+ 3x M3x10) Rear chamber (3x M3x10) "Flash hider" (M14x1 CCW, also needs a very tight fit) Middle chamber (4x M3x20) Insert (Needs a tight fit) Outer shell