Multi function pencil-case

myminifactory

------------------------------------------------------------------------------------------------------------------------ READ BEFORE PRINTING! First of all, this is a non-commercial print, this means you are not allowed to sell files or prints of this model. It would be nice not to find this for sale on etsy... ------------------------------------------------------------------------------------------------------------------------This is a protective case for tablet pencils, and it has become one of my favorite designs. I bring it almost everywhere I travel, and it has held up well so far. Features include: Pen protection:The main reason I created the case. I wanted something to protect the pencil when I was travelling. It also makes the pencil harder to lose! Tablet stand:The case can be used to give a slight angle to your tablet, improving the ergonomics when sketching. Two different types of pen stand:Instead of letting your pencil rolling away on the table, I included two different ways to place it in the case. Leaning the pencil against the case or standing upright.  Adapter storage:I tend to (almost) lose the adapter all the time. Since the battery in the pencil is quite weak and charging the pencil in the tablet is a recipe for disaster, I added a small slot for the adapter inside the case. I now always bring the adapter with me, and most important, I know where it is... ------------------------------------------------------------------------------------------------------------------------ GENERAL INFORMATION To prevent the pencil from moving inside the case, I recommend cutting a small piece of dish sponge and stuff it in the bottom of the case. The case in the pictures has been sanded and painted. It looks fine without, but it really gives the case a really nice finish. ------------------------------------------------------------------------------------------------------------------------ PRINT SETTINGS Print both components in the default orientation. This orientation will ensure that you won't need support material. Do not use support material! This is especially important on "case.stl" since you won't be able to remove the support material behind the button. I recommend a 2mm wall thickness to make sure the spring for the button is solid. An infill of 50% or more is preferable, It's not needed but I think it gives the case a more "sturdy" feel. ------------------------------------------------------------------------------------------------------------------------ FEEDBACK I do appriciate any feedback you may have. If you've printed the version with a o-ring groove, let me know how it turned out!