MXL My Customized Parametric pulley - lots of tooth profiles

thingiverse

Customized version of http://www.thingiverse.com/thing:16627 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following options: Pulley bore height is set to 7 units. Retainer height is set at 1.5 units. Pulley base diameter is fixed at 15 units. Idler height is also set to 1.5 units. The idler feature is currently switched off. Additional tooth depth has been adjusted to 0.5 units. Additional tooth width is now set to 0.2 units. Motor shaft size is specified as 5.2 units. Profile selection is set to 1. M3 nut hex specification is enabled for 1 unit. Distance between M3 nut and shaft is fixed at 1.2 units. Depth of M3 nut is set to 2.7 units. Number of nuts required is set to 1 unit. Measurement of M3 nut flats is specified as 5.7 units. The retainer feature has been disabled. Nut angle is currently set to 90 degrees. Pulley top height is adjusted to 12 units. Total number of teeth on the pulley is set at 16 units. Diameter of M3 thread is fixed at 3.2 units.