MXQ 105 Micro FPV Quad

thingiverse

This is a complete re-design of my previous fpv quad design - Micro Spider Quad MSQ100 FPV: http://www.thingiverse.com/thing:1478859 It uses the same electronics but is a few grams lighter and is now X-form. Wheelbase is ~105mm, This new version will accept up to 66mm props with a bottom mounted battery. (A 400mAh can be mounted on top if using regular hubsan-size props.) I've also included a file for tabs to glue to your batteries to help keep them in place. UPDATE (6/19/16): I had a request for a version of this without the built-in posts. I've added files of the bottom and top plate without the integrated posts. You should be able to use your own M3 threaded spacers. UPDATE (11/2/16): I had a request for a version to fit the SP RACING EVO brushed controller from Banggood. I have uploaded the base, but it is untested. I'm not sure about the USB access. If you print it, please comment below if it works for you. Thanks! It is designed around the following components: Micro Scisky 32bit brushed FC from Banggood 8.5x20mm motors from Banggood 600TVL 1/4 Micro CMOS camera from Banggood FX758-2 5.8G 200mW VTx from Banggood Pololu 5V step-up regulator (U3V12F5) Hubsan or Parrot props 4 short #2 servo/wood/sheet-metal screws Weight of frame: 8.2g Assembled weight without battery: 42g AUW w/410 mAh battery: 53g Print Settings Printer Brand: Ultimaker Printer: Ultimaker 2 Rafts: Doesn't Matter Supports: No Resolution: Standard or high Infill: 18% Post-Printing If the top seems to be too tight to fit into bottom, just run a small round file around the inside of the post pockets a couple of times.