My Arduino Ether LivingColors case

thingiverse

Created with Customizer! https://www.thingiverse.com/apps/customizer/run?thing_id=202525 Instructions Using the following options: Front Hole Position = 13 inches Thickness Of Side Walls And Bottom = 1.6 mm Gap Between Wall Thickness = 0.6 inches Arduino Type Selection = Microcontroller Model 0 Custom Height Option = 20 inches tall Height Of Usb Plug Hole Depth = 13 inches Height Of Power Plug Hole Opening = 14 inches Standoff Diameter Choice = 1.6 mm thick Back Hole Width Dimensions = 5 inches wide Clearance Between Arduino Board And Wall Spacing = 1.5 inches clear Shield Number Three Input = None selected Shield Two Number Input = 9 points available Shield One Number Selection = Limited to two points Back Hole Position Depth = 30 inches away Front Hole Position Second Location = Positioned at 40 inches wide Front Hole Width Measure Two = Measures 20 inches in width Front Hole Width Original Setting = Remains 20 inches in original setting Height Of Standoff Component = Set at 7 inches high Standoff Hole Diameter Selection = Selects diameter size of 2.9 mm thick Height Of Ethernet Plug Opening = Positioned 16 inches from bottom Front Hole Height Second Depth = 5 inches below top surface Front Hole Height Original Setting = 5 inches as per design requirements Custom Label Assignment = Designates label as "LivingColors" custom identifier Back Hole Height Measure = Dimensions remain set at 5 inches in height