My Customized Box with Lid

thingiverse

Human: Customized version of Thingiverse: http://www.thingiverse.com/thing:806968 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=806968 **Instructions** Using the following settings: - Deep holes reach 40 deep. - The standard type lid is used. - A thumb divot is created on top. - Coin size and placement options are set: coin diameter equals 26 units, coin gap width is 2.5 units. - Lid drop off equals 7 units from the surface level. - The box is being generated along with all parts and subparts, number of outer Y-axis lines equals 2, and X-axis offset from box base is set at 3 units. - Box wall thickness equals 1.65 inches. - Box component overlap ratio is set to 50%, box part length along X-axis also set at 50% the part length of outer Y axis component placement spacing gap width between elements of parts is set very low, only 0.05 inches. - The lid offset from its base level equals 3 units. - Generation for standard and alternative lids have been turned off. - A separate coin slot compartment is not being used for any part design at the moment