My Customized Jellyfish - drooloops

thingiverse

Customized version of http://www.thingiverse.com/thing:243994 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=243994 Using the following options: Setting Number Inner Num to 2. Setting Radius Inner to 10. Setting Twist Inner Angle to 46 degrees. Setting Width Lower Part to 0.8 units. Setting Stigma Number to 5 units. Setting Suffix Sigma Value to 1 unit. Setting Twist Outer Angle to 36 degrees. Setting Drag Outer to 30 units. Setting Ratio Inner to 70 percent. Setting Height Stem Inner to 2 units. Setting Height Junctions Upper Part to 8 units. Setting Radius Suffix Stigma to 7 units. Setting Number Outer Num to 10. Setting Length Lower Outers to 60 units. Setting Support Diameter of the Joint Fitting Radius to 2 units. Setting Inner End-to-End Length to 7 units. Setting Width Spinal Ridges to 2 units. Setting Height Upper Part of Stigma to 0.2 units