My Customized Multiline Tag or Keychain

thingiverse

ADNAN created a customized version of thingiverse.com/thing:739573 using the customizer tool found at thingiverse.com/apps/customizer/run?thing_id=739573. Instructions are provided below to replicate the options used: * The font narrow width was set to 0. * Lugs were designed in a plate style. * Bars were displayed in bar-only mode, trimmed on each end with zero length adjustments made. * Text was colored Dark Red and read from left to right. * Lug widths were standardized at 5 units and bars followed the same specifications. Ruler unit settings ensured increments of ten units separated by minimal line spacing at 1.4 units. Settings chosen: * Exteruder selection is fixed to monochrome printing capabilities utilizing extruder 1. * Outline style utilized for font outlining featured a rounded profile while outer margin width was set at one unit with extra extruder selected as the primary layer print device. The selected extruder and color combinations are summarized as follows: * A minimum of one extruder was used. The preferred option utilized monochrome settings which employed only single color profiles. The default outline, font selection criteria, along with border options chosen were: * No specific weight for the Lobster font typeface. * Rounding out additional parameters and print selections are shown as follows: Selected style: Lobster. Line thickness measurements in order to establish an outer edge setting resulted at three point four units, with outline size remaining set within established default criteria at 12-point settings. Bordering configurations followed by extruder selections were outlined below. Border options: * Exterusion type is extruder2. * Print area colors remained dark while borders featured black hue. Additional settings not previously noted: * Inner margins width were established at 1 unit; and a border layer width resulted at the set value of 0. The remaining print parameters in combination follow the list provided: