My Customized NUT JOB | Nut, Bolt, Washer and Threaded Rod Factory

thingiverse

Customized Version of Thingiverse Model ID: 193647 Created with Customizer - Get Your Own Here! Using These Options: • head_height : Set to 5 Units • nut_height : Set to 6 Units • head_type : Hexagonal Configuration • nut_thread_outer_diameter : 9mm In Diameter • type : Standard Bolt Configuration • nut_thread_step : Set to 2 Threads Per Unit Length • outer_diameter : 20 Units Long • thread_outer_diameter : 8mm Thick • thickness : Just 2 Units Wide • nut_step_shape_degrees : Measuring in Degrees at 45 Units • texture : Not Included - Optional Addition • nut_diameter : The Diameter of the Nut Measures to 12 Units • step_shape_degrees : Calculated as 45 Units in Shape Formed • slot_depth : Only Going Inwards by 2 Units • resolution : Measuring In At 0.5 Unit Intervals • inner_diameter : Inner Circle Forms at 12mm Radius • thread_step : Incrementing Every 2 Threads Per Rotation • nut_type : Typical Standard Normal Setting Used • facets : Dividing the Entire Geometry Into a Polyhedral Shape With Six Facets • non_thread_length : Optional Extra Length Beyond The Thread's Tip Point - Set To Zero Here • slot_width : Slotted Narrowest Section Spans to 1 Unit Wide At Max Stretching Position • wing_ratio : Proportional Measurements For A Symmetrical Ratio Across Full Assembly Width Set To 1:1 • drive_type : Fitted for Socket Use And Design • thread_length : Each Thread Section Takes Up Around 25 Units As Standard • countersink : The Angle At Which Each Screw Hole Has Been Countersunk From Original Height Point – Measured in at Degree Positioning (Counter sinking Depth): Set to a total depth of 2 units. • head_diameter : Forming an In-Circular Profile Head that Meets at Radius at the same Diameter as the Thread • non_thread_diameter : Zero units assigned here • drive_diameter : Set Drive diameter measures only five units.