My Customized Parametric plug - OpenScad - rudy Ruffel

thingiverse

Customized version of http://www.thingiverse.com/thing:593002 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=593002 Instructions Using the following options: Second Angle Horizontal is set to 90 degrees. First Angle Horizontal is locked at zero degrees. Plug 0 Horizontal is fixed at zero degrees. First Angle Vertical is adjusted to 90 degrees. Fifth Angle Vertical reaches a maximum of 180 degrees. Fourth Angle Vertical levels off at 90 degrees. Third Angle Vertical is calibrated to 90 degrees. Plug 0 Vertical remains unchanged at zero degrees. Resolution for the cylinder is set to 100 points. Thickness of wall is fixed at 3 units. Second Angle Vertical aligns with 90 degrees. Length measures 6 units. Third Angle Horizontal adjusts to 180 degrees. Height stands at 20 units. Cylinder mode is enabled. Number of plugs reaches four. Fourth Angle Horizontal sets a mark at 270 degrees. Fifth Angle Horizontal is reset to zero degrees. Width extends to 6 units.