My Customized Parametric pulley - lots of tooth profiles

thingiverse

Here is a rewritten version of the original text with improved tone, voice, and phrasing while maintaining an active voice. Created Customized Version from http://www.thingiverse.com/thing:16627 Using Customizer! Instructions to Follow: With these settings in mind, we have: Pulley Diameter (m3_dia) Set to 3.2 Height of Pulley Bumpers (pulley_b_ht) Fixed at 10 Units Idler Height (idler_ht) Precise at 1.5 Units Number of Nuts (no_of_nuts) Counted as One Unit Additional Tooth Depth (additional_tooth_depth) Left Empty Motor Shaft Diameter (motor_shaft) Measured at 5.2 Units Distance between Nuts and Nut Shafts (nut_shaft_distance) Established at 1.2 Units Extra Tooth Width (additional_tooth_width) Calculated to 0.2 Units Depth of m3 Nut Thread (m3_nut_depth) Set at 2.7 Units Length of Hexagon on M3 Nut Thread (m3_nut_hex) Identified as 1 Unit Angle between Nut and Pulley Bumper (nut_angle) Determined to be 90 Degrees Total Number of Teeth on the Gears (teeth) Specified as 32 Units Count of Retainer Pins (retainer) Marked as Two Diameter of the Outer Gear Pulley (pulley_b_dia) Fixed at 40 Units Height of Retainers (retainer_ht) Confirmed to be 1.5 Units Length of Flat Side on m3 Nut Thread (m3_nut_flats) Precise at 5.7 Units Final Shape Profile Set (profile) Measured to 6 Units High Maximum Height of Pulley Teeth (pulley_t_ht) Defined at 12 Units