My Customized Parametric pulley - lots of tooth profiles

thingiverse

Created by the Customizer! You can see the original thing here: http://www.thingiverse.com/thing:16627. To assemble this device, follow these steps: - Using the controls below, make the necessary selections: * nidler = None * motor_shaft = Five units * m3_dia = 3 point two millimeters * additional_tooth_depth = Zero points two zero millimeters * pulley_t_ht = Eight points eight centimeters * nut_angle = Ninety degrees * nut_shaft_distance = One point two centimeters * retainer_ht = One and five tenths of a centimeter * pulley_b_dia = Two decimillimeters meters units * no_of_nuts = One unit * pulley_b_ht = Zero centimeters * additional_tooth_width = Two tenths millimeters points * m3_nut_flats = Five and seven tenth inches wide * retainer = Zero value units * profile = Thirteen profiles units * idler_ht = One point five decimeters * m3_nut_hex = Point one zero deciliters * teeth = Ninety point units * m3_nut_depth = Two and seven hundredths points