My Customized Parametric pulley - lots of tooth profiles

thingiverse

Customized version of http://www.thingiverse.com/thing:16627 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following settings: Motor shaft diameter is set to 9 millimeters. Pulley bearing height is set at 8 millimeters. Profile width is chosen as 6 millimeters. Idler gear is disabled, but idler height is set to 1.5 millimeters. M3 nut depth is precisely measured at 2.7 millimeters. Additional tooth width is adjusted by 0.2 millimeters. M3 bolt diameter is specified as 3.2 millimeters. Extra tooth depth is left unchanged at 0 millimeters. M3 nut flats are set to exactly 5.7 millimeters. Nut angle is deliberately set to 90 degrees. M3 nut hexagon is selected with a value of 1. Teeth count on the gear is carefully chosen as 20. Pulley thickness height is accurately set at 6 millimeters. Number of nuts is decided upon as one. Pulley bore diameter is precisely measured at 20 millimeters. Retainer mechanism is deliberately disabled, and retainer height is set to 1.5 millimeters.