My Customized Parametric pulley - lots of tooth profiles

thingiverse

Customized version of http://www.thingiverse.com/thing:16627 Created with Customizer! http://www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following settings: pulley_t_ht is set at 12 points additional_tooth_width is adjusted to 0.2 units m3_nut_hex is selected as 1 option m3_nut_depth is specified at 2.7 units retainer is enabled with 1 setting no_of_nuts is set to 1 unit motor_shaft diameter is fixed at 5.0 mm additional_tooth_depth is left off pulley_b_dia is set at 18 points profile is chosen as option 13 idler_ht is adjusted to 1.0 units m3_nut_flats are measured at 5.7 mm retainer_ht is set to 1.0 units teeth number is fixed at 36 pieces nut_angle is calibrated to 90 degrees nut_shaft_distance is measured at 1.2 units idler is enabled with 1 setting m3_dia is specified at 3.2 mm pulley_b_ht is adjusted to 9 units