My MPCNC Corner

thingiverse

As I started printing the MPCNC, Going through the parts, I was not pleased with the corner mount system. Especially the belt restraint. So I created a compound version that restricts both X and Y tubes, AND secures the belt all at once. Also necessary is a foot to hold the tube, and a foot for the build surface. In true Blue Peter style... Here's one I made earlier... https://www.thingiverse.com/thing:3835664 The belts loop around an M3 bolt, then get pushed into the slot. Tension must be applied to the belt, but no problem exists. I will likely design that next week. NOTE: You need to print two of each corner, mirrored parts, And 4 of the shoe. Also required are 2 - 4 * 100mm M6 Bolts, I used this one... https://www.screwfix.com/p/easyfix-roofing-bolts-m6-x-100mm-10-pack/4964j