my PLUS version of Tronxy X5SA 400 pro

thingiverse

06-02-2022 Update with a new energy chain management. 03-02-2022 for the first shot it works good, see pictures. i have extended the BL touch as Z sensor. All square nuts I ve attached with self-adhesive tape additionally. that has mounting advantages. the screws do not loosen due to the vibrations, since the adhesive is also between thread and screw. The mounting of the fan works, but I think, if I feel like it, I do it as a swallowtail nut and secure it with a screw. is more maintenance friendly. or who wants... that Fusion File is indeed uploaded with 27-01-2022 This is my PLUS version of the Tronxy X5SA-Pro 400. Almost all parts can be adapted to the smaller / larger brothers. The X5SA pro is a reasonably good basis. You can't get a solid basis cheaper. But you still have to do a lot to get a good printer. Goal of the conversion: - Completely enclosed, tightly possible for later heating - Direct drive - Water cooling - new firmware - new board - better Z drive - more stable and above all: better cables (suitable for drag chains) Status 2022-01-27 Frame angle - tested and installed Switch housing - tested and installed Z-drive with one motor - tested and installed On / off housing - tested and installed Connector housing - tested and installed Water expansion tank - should work as a further development from an older version that was installed Cable tray holder - tested and installed Holder for water installation - to come Holder for hotend - design ok, not tested I have installed parts in PETG I uploaded the current Fusion File. who wants to... https://grabcad.com/library/my-plus-version-of-tronxy-x5sa-400-pro-1 here is the Fusion File have fun