My wire rack shelf purse holder.

cults3d

My wire rack shelf purse holder. I made this purse holder for my wife. If you have this kind of wire rack shelves, with the smaller wires about 1" apart, then this purse holder should fit. It will slip over the front face. I added a brim to keep the rear legs stable during printing. It needs to be trimmed away post print. I also designed a shaft collar mount. This one fits on the 25.5mm tube of the wire shelf. You will need to get some small screws and nuts for the shaft collar. 2X12mm and nuts. I added a small ring on the bottom inside of the collar to fit into the grooves in the 25.5mm tube. It is very hard to hold the nut in place while trying to start a screw. Especially on a wire rack tube. I found these brass threaded inserts on Ebay. Search for threaded insert m3. The inserts I chose use a 3mm screw. I chose a 3mmX 20mm socket head screw. 12 or 15mm's long might be better, but I had 20's in stock so that's what I used. To insert the insert, thread a screw into the hole. Thread the insert onto the screw. Screw it down until it embeds itself into it's pocket. Then back the screw out. TADAA!!! it's embedded. Much easier to install onto a wire rack tube now. I designed 3 purse holders ph r.stl – my original design, fits over the front face of a wire rack shelf ph c n.stl – shaft collar using nuts 2mm's ph c i.stl – shaft collar using threaded inserts 3mm's Printed in PLA .2 layer 50% infill