MyLaps Transponder Mount

thingiverse

This is a MyLaps transponder mount that can be printed and then attached to your car using your favorite type of adhesive. There are two versions available, one with built in support and one without. Choose which one you would like to use and print it. I have had problems with the version without support printing, so print at your own risk. Also, I am aware that the included supports on the version with support are too small to print properly (or at all). There does not seem to be any problem with this as the print should still be usable. Both versions require the printer to be fairly good at bridging to have a print that will fit the transponder, otherwise the part will be far to tight to fit the transponder. Once the print is ready just punch out the center support and clean up the inside of the mount. Print Settings Printer Brand: Robo 3D Printer: R1 ABS + PLA Model Rafts: Doesn't Matter Supports: No Notes: Retract seems to cause problems with the smaller sections of the print, however if you are confident with your printer's retraction settings feel free to use it as it will clean up the print.