N Scale B&O Signal Tower

thingiverse

This is a N Scale B&O Signal tower. If you want it lighted you will need to figure out how you will run wires and drill extra holes for them accordingly. In addition to this print you will need: Materials: 1.2mm Brass Tube(top signal masts) 1.4mm Brass Tube(base support pole) 603 and 403 SMD LEDs with 40 or 42 AWG wire. B&O Targets can be found here: https://www.thingiverse.com/thing:4749940 Since the top mast is 1.2mm my other N Scale lighted signal parts designs will work as well to create your or variety. Tools: 1.2mm Drill bit(hole clean up) 1.4mm Drill Bit(hole clean up) Hobby Knife(cleanup and cutting) Sanding tools(clean up) CA Glue. Assembly: While I made these to be lighted you will need to come up with a plan to run wires on the outside or inside the tubing and drill holes in various parts as needed. You will need to use 603 SMD and possible 403 LEDs to get them to fit. Take the two platform pieces and glue together so the ladder access notch matches. Carefully fold the hand rail at the small notch points and glue around edge of platform. Two are provided since it is delicate and easily broken. Slide U shaped ladder mounts onto 1.4mm tube and add platform and base to your desired height. Cut and glue ladder in place. Create masts to your own specifications and insert on ether side of top platform.