Namco 2x6 Multi Mounting plate

thingiverse

These are 2 parts that are for either a Namco 246 or a Namco 256 "C" rev - it fit and screws into where the DVD player would fit. I split it into two parts and print the front plate "face down" as its stronger than printing all as one piece. I have also provided the single piece if people are so inclined. The small stabilizer piece is to make it so there is less flex on the front plate when inserting and taking out the usb cables in the front. It should line up with a screwhole on the middle bar. I print this with the small piece with the hold on the bottom. This is a perfect fit for the older ODE. If you have a newer "RevB" ODE - the IDE connector is in a slightly different spot, so you will have to dremel a little bit of the 3dprint out of the way for it to fit.