NASA Press 'n' Slide Clamp

grabcad

Just my initial vision of what the clamp should be. The clamp has 2 embossed fixtures which are locked in after the slide. To remove the clamp one has to press the other side of the clamp which will pry open the fixture and the clamp will be released. Okay so the problems with this design are: *FDM printed ABS might have too low elasticity module so when one presses down the other clamp, the wall between the rail and the fixed interface might start to deform permanently *The fixtures might not hold up *After some use the clamp will loosen up too much *etc.