NAZA lite 2022

thingiverse

HATE the old flamewheel its clumsy, shaky and a lot of wobble, hate to waste the excellent naza lite that flies perfect so decided to print something small and stiff to use the old fashion Naza lite with cold war 30 amps ESCs, downloaded a lot of models, none of them did it for me, all were big and shaky, the best was the mavic clone but it was too big and heavy for me, needed something smaller. needed 16 3mm screws 25mm long 16 3mm screws 10mm long 4 35mm standoff from old QAVs the idea is to use the pla as nuts in the joints avoiding more weight, dont use brute force with the screws, maybe epoxic is a good help. parts 1 frame (print 2) 20% infill 1 arm have to invert it 2 each if TOC set the triangles for the same direction 15% infill 1 light (taken from here https://www.thingiverse.com/thing:858925) 20% infill 1 GPS(taken from here https://www.thingiverse.com/thing:178714)20 %infill 1 feet (like the arms have to print it) 20% infill all the ideas are wellcome allso if you can make it better hope to test it soon to bring back the old school NAZA lite. maybe its a good idea to get rid of the old ESC and to put better motors but for now it will work for me.(hope) UPDATE UPDATE UPDATE IT FLYES! and it was perfect, way better than flamewheel, solid sharp, no wobbles very very close to my phantom 4. It is my final design, it fits perfectly to my requirements so the next is to fit the GPS antenna, camera and VTX. Maybe the 4 landing skids are too much, maybe with only 2 or none... its perfect too. (DONT PRINT THEM THEY ARE NOT NEDDED) IT IS PERFECT FOR ME! There is a lot of space to fit anything, the top plate and the bottom plates are free and non covered by the propellers. Maybe its time to work a small PLA Gimball to use a Hero2 direct to the VTX but thats the next step in a fork for this design, hope you like it, if you print it or mod it please let me know! there is a lot of chances that your mods will make it better than the original