Neato-Botvac charging-base wall-mounts (Botvac D3 Connected- should match to other models with same charging-base)

thingiverse

As my botvac always pushed his charging-base around the room (it´s placed in a room with wooden floor), it often didn´t finish it´s cleaning cycle due to not finding the base anymore. These two holders can easily be snapped into the stock charging base (mine is a Botvac D3 connect, should match to many more charging-bases). Then just screw the base onto the wall... The base will be placed where it is intended... no more dead botvacs with empty batteries anymore :-) Installation: - print the holders - take the charging-base and find the two gaps behind the wire-holding-noses (see pics) - slide each holder *from the outer side* into these gaps, until they can be pushed on the noses (they will have plenty of sideplay.... this eases the mounting on the wall) - take 2 Screws with 4,5mm diameter and 30mm to 40mm lenght. - mount the base onto the wall... please do not tighten the screws too fast as the holders might get cracks... Enjoy :-)