Necklace hanger

thingiverse

I liked the necklace holder, but thought it was a little to angular. I redrew it in Solidworks to change the openings to hearts. I also increased the square hole size to avoid any problems with the fit being too tight. The original column mount is unchanged, but it fits 1" PVC pipe too well to ignore. This barely fits on a Prusa Mendel, so make sure it is well centered. Instructions Print, cut plastic pipe to length for your necklaces. I used 10.75". Hot glue the base to the pipe, making sure it is vertical. The top just sits in the pipe, making for a good pivot. A little spray paint would really set it off. Variation: You could print 2 tops and use one for the bottom.