Neptune 3 Pro Bed Level Test

thingiverse

Simple 235x235 bed level test for the Neptune 3 pro that takes up the whole bed, so u can make sure you have the whole bed dialed in, first use the single centered test to dial in your z height, then use the five square test to get the whole bed dialed in. doesn't matter what layer height u have it at as long as u have first layer set to 0.2mm if you go to print it and its too big for your bed u need to manually adjust your bed size from 220x220 - 235x235x280, if your having issues with bed leveling i suggest leveling your gantry to your bed using 2 cd or game cases, check out how this guy did it here https://www.reddit.com/r/ElegooNeptune3/comments/wekdax/leveling_your_xaxis_the_abba_beatles_way/ I suggest putting the cases right on the bed rather than the frame like he does in the picture make sure to move the bed back so the gantry is exactly in the center of the bed and do your best to also center both cases as best as u can on each side to rest the gantry on then give them both a bit of a tug once the gantry is resting on them to make sure they both have the same amount of weight on each side, then tighten, relevel and reset z height and use these tests to get the perfect first layer.