Nerf Dart Compatible Drain Blaster

prusaprinters

<p>An adapter which makes it possible to shoot Nerf Darts with a drain blaster through special capsules.</p> <p>WARNING:<br/> DO NOT AIM OR SHOOT AT HEAD OR EYES!<br/> USE AT YOUR OWN RISK!</p> <h3>Print instructions</h3><p>Printing:</p> <p>1st Side:<br/> Print on the side that connects to the drain blaster<br/> Use supports<br/> 50% infill<br/> 4 perimeters</p> <p>2nd Side:<br/> Print on the side that connects to the drain blaster<br/> Use supports<br/> 50% infill<br/> 4 perimeters</p> <p>Single Shot Capsule:<br/> Print on the side that connects to the adapter<br/> Use supports<br/> 5% infill<br/> 4 perimeters</p> <p>Triple Shot Capsule:<br/> Print on the side that connects to the adapter<br/> Use supports<br/> 5% infill<br/> 4 perimeters</p> <p>Ten Shot Capsule:<br/> Print on the side that connects to the adapter<br/> Use supports<br/> 5% infill<br/> 4 perimeters</p> <p>Assembly:</p> <p>Materials you will need:<br/> 6 m3 screws 25mm or cut to fit<br/> 6 m3 nuts<br/> 12 3mm washer<br/> 1 15mm×2,5mm o-ring<br/> 2 60mm×2,5mm o-rings(per capsule)</p> <p>Main Blaster:</p> <p>Put the drain blaster between the 1st and 2nd side.<br/> Put a washer on each screw and screw them in.<br/> Before you put the nut on, place another washer on the screw so that there is a washer on each side.<br/> Put the nuts on and tighten them.<br/> Then place the small o-ring in the slot on the small connector piece.</p> <p>Capsule:<br/> Put the two big o-rings in the slots for the o-rings.</p> <p>WARNING:<br/> DO NOT AIM OR SHOOT AT HEAD OR EYES!<br/> USE AT YOUR OWN RISK!</p>