Nerf Rival Kronos extra front plate attachments and adaptors

thingiverse

Extra barrels for the Kronos front plate by CyanAce. Well, OK. I didn't make new barrels, but I did take the flash hider and muzzle brake front plates and turn them into attachments. Also, I'm working on relwolf's six shot plate and adding a cover for the hole. Finally, I saw the original Thing and said, 'Ooh yeah.' I just completed the first of several adaptors for the front plate that allow it to fire other darts. This one just slightly opens the air restrictor to fire a single elite at normal velocities. Note that due to the adaptors disabling the air restrictor I don't recommend dry firing with these in. Also, don't store your blaster with the adaptor locked in as this can wear out the AR spring. I took the fit for the dart from BellinghamXC's Strongarm 9 dart cylinder which is why it is listed as a source. UPD1 Okay, so I tested the 'high power Elite adaptor' and had no increase in power. I think this would require extra o-rings where the front plate meets the barrel and again where the adaptor meets the plate. This one comes off the 'Coming Soon' list. UPD2 I've put the high power adaptor back on the list. I took the o-ring out of a BuzzBee Rogue and put it on the adaptor, which works like a charm now. The darts do tend to spin out at the higher velocities so I'll be extending the barrel. I'll then add a socket for the o-ring and release the file. UPD3 High power Elite adaptor is up! It uses the o-ring from a BuzzBee Rogue as previously mentioned. The o-ring dimensions are: Outer Diameter: 20mm Inner Diameter: 16mm It's a little tight so you might want a slightly smaller ring. I found that by rotating the adaptor as I put it in I was able to get it to work nicely. Stay tuned - the Mega adaptor is coming up, and I have an idea to turn it into an assault pistol like the Meaker MK18. UPD4 I've added the front plate, modified from relwolf's model. It includes a cap and a clip piece to hold the cap in. I recommend you print the clip with a brim. Also, you get your ironsights back! I added an ironsight to the rear plate piece, so that's here as well. UPD5 I've added the Mega adaptor as promised. Initial tests were not promising, but then I took some duct tape and added a single layer to the transition where it narrows from 21mm to 20mm. It seals great and hits slightly harder than a Mega Cycloneshock. Also, I've uploaded pics of my print quality as requested by MKSA. Coming soon: Mega adaptor Double/Triple Elite adaptors Note that updates are currently on hold as I am putting together a laser tag system. It should be up here by the end of April. Enjoy your upgrades:)