Nerf Rival Kronos Plunger Seal Shim

prusaprinters

<p>Plunger Head Shim for Nerf Kronos / Heracles (and possible other Kronos reshells)</p> <p>Place this shim on the plunger head underneath the O-ring for a tighter seal.</p> <p>Same concept as the oldschool teflon tape wrapping method to tighten seals; but more permanent -I've had issues with teflon tape squishing out of place.</p> <p>SML variant doesn't stretch the O-ring as much. use if the tighter seal adds too much drag and becomes a detriment to fps.</p> <p>Plunger Fill Spacer:</p> <p>the Kronos Plunger Tube has a very slight Taper at the front;</p> <p>This narrow area can damage the O-ring seal if using the Above Shim to get a tighter fit.</p> <p>Therefore, must press fit this shim into the bottom of the plunger tube to block the plunger from entering Tapered section.</p> <p>Sacrifices a few mm of air volume, in exchange for Seal Durability.</p> <p>Warning: may need to remove Ratchet Lock from blaster after shimming, depending on spring/spacers used.</p> <p>Impact resistant material recommended; such as high durometer TPU.</p> Category: Toy & Game Accessories