Nerf Strongarm Mod: 9 Dart Cylinder

thingiverse

Youtube Video:https://www.youtube.com/watch?v=i1CMfNDiqRg Update (2016/04/18 @ 17:47): Edited barrel bore again, is now a happy medium between the first 2. It is both loose enough for stiff, newer darts and tight enough to have less fishtailing than the previous version. A mod for the Nerf Elite Strongarm blaster to increase the capacity from 6 darts to 9 darts. Consists of a new 9-dart cylinder and a new internal piece to make the cylinder rotate 40 degrees rather than 60. Print Settings Printer: LoboCNC Sehome Printer Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: As high as possible Infill: 20% Notes: It's very important that the cylinder print does not curl up off of the print bed. If you need rafts to make sure this doesn't happen, then use them, it's what I had to do. On the "spinner" piece, there are some sudden overhangs. My printer prints those just fine, but you may need support material there. Post-Printing In addition to the two printed parts you will need a rubber band.