Nespresso capsule holder

thingiverse

Like Nespresso coffee but fed up with having capsules everywhere? Think the commercial capsule holders are far too expensive? This thing is a parametric Nespresso coffee capsule holder, so you can make a holder for as many capsules as you like (limited by the size of your build table!) The capsules are dropped in from the top of each row, and are removed with a simple pull and lift movement from the bottom. Please note: This is NOT endorsed by Nespresso. Instructions Print, affix to wall/cupboard door. Load with 5 capsules. Enjoy. You can print multiple holders and fit them side by side to make a Nespresso 'wall' - the 'cover' picture shows 5 of the 'x5' holders, each glued together with epoxy, then glued to the tiled wall. Caffeine-tastic! The files are as follows: capsule-holderx5.stl - A 5 capsule nespresso holder. This just fits on the build platform of my Reprappro Mendel. (it actually JUST holds 6 capsules due to the way the capsules sit). My photos use this model. capsule-holderx3.stl - A 3 capsule nespresso holder, for those with smaller build platforms. capsule-extensionx2.stl - A 2-capsule extension piece, which together with the above will give you a 5 holder nespresso thing. Build tip: I found I needed to have a 60'C heated bed in order to prevent the corners peeling up - at 50'C, it tended to lift!