Nespresso Pod (Original) Holder (9.5")

thingiverse

This is a remix(ish) of DanLuc's design. The gap between the flat surface and where the angled tab begins was lengthed a little, as the "Bestpresso" Cheapo pods have a bubble at the top which made it hard to get in and out. I also made the whole thing a little wider, as my cheapo pods don't always have the most accuracy. The most significant change in appearance was the skeletonized surface, and the screw mounting holes, which were designed with a #2 countersunk woodscrew in mind (which if tightened down to be quite snug, fit very well). I also wanted to use these under my cabinets, and DanLuc's design was unfortunately just a little too long with two sections, but way too short with just one. Thus I made the total length of this about 9.5 inches, which fits my cabinets very well. Each length (2 pieces) just barely fits 7 pods, with the last pod hanging slightly out of the front. The downside to my design is I did not make a middle section to make them even longer if you so require, but if I get a few requests I will consider it.