NetApp DS4243 DS4246 - HPE 3par M6720 disk tray

thingiverse

This is a remake of crsleeth's thin disk tray.I used his design as a reference, replicating the handle, the two side indents, the height, and the thickness measurements. However, I noticed that his version didn't fit over a 3.5" drive properly, and the screw holes were misaligned. To address this, I increased the width for a better fit and adjusted the screw hole spacing from 100.6mm to 101.6mm.Additionally, I found that the material-saving holes in the original design compromised the print quality with the PETG I use. Since the printing time is unaffected by the presence of these holes, I opted for a solid design without them for a cleaner appearance.I am using these in a HPE 3par m6720. I am using 6#-32x1/4" Phillips flat head machine screws, to mount the drives.