Netfabbed Turnigy 9X FPV Monitor Holder

thingiverse

Began printing thing:711906 and noticed it was printing in two pieces. Cura 14.12.1 sliced the longer bracket from thing:711906 with a split down the middle. There does seem to be an artifact in this area, but it may also have to do with slicing settings. Haven't checked the original thing:703700 that this is remixed from to see if it's there too. Ran the Longer_bracket.stl through Netfabb online and the artifact went away. Screenshot of first layer of original and fixed model attached. Have yet to print it, but wanted to share. Instructions Have not yet made. Original says to print with at least 50% infil. I was planning on trying less. Other planned slicer settings: -3 mm PLA filament -55 deg C bed, 45 deg C after initial layers -185 deg C hot end -2 walls -0.3 mm layers -50 mm/s speed