Nexus 7 mount (2012) + recharge pins

prusaprinters

<p>This mount has room for two pins, that will charge the nexus when you put it in the mount. You will need:</p> <ul> <li>An usb cable</li> <li>A small peace of conductive metal, like a nail or similar. Preferably cobber. Iron will do.</li> <li>Sodering equipment</li> <li><p>Wire cutters<br/> Proceed by cutting the peaces of metal in two bites, one just a tiny bit longer than the other. about 5-7mm in length. they should just stick out a mm or two out of the mount. Make sure they can move freely through the holes. this way they can automatically adjust there height so both connects to the tablet.<br/> Use wire cutters to cut the usb cable. find the + (red) and the - (black) wire and solder them in one end of each of the pins.<br/> insert the pins into the mount from the bottom, along with the cable and fasten the lid with the screw. The + pin goes to the hole furthest near the edge and the screw hole, and the - pin goes to the other hole.<br/> If the pins arn't connecting, you can use a hot pin to move the holes a bit.<br/> If the print is too wide for your tablet, you can use some tabe to thicken one side of the mount, and thereby make the tablet slot smaller.</p> <p>Enjoy!</p> </li> </ul> <h3>Print instructions</h3><p>Category: Tablet</p>