Nikon IX Nikkor Adapter Plate

thingiverse

These are Adapter to Convert a IX Nikkor Objective to use on a Normal Nikon F Mount Camera. On the 30-60mm Silver and the 60-180mm Black Parts you need to unscrew the middle Bulky Plastic Part which are Hold with 3 Little Screws and replace it with the 3d Printed part. On the 20-60mm Black and the 24-70mm Blck Part you need to cut plastic away and glue the new Parts On IX Nikkor - 30-60mm Silver you need to remove the Medal Part with the electronic too. With that it lose the Digital Function and is only a ful Manual Lense Finished Version: -IX Nikkor - 30-60mm Silver with and without Digital Port -IX Nikkor - 20-60mm Black -IX Nikkor - 24-70mm Black -IX Nikkor - 60-180mm Black HINT! I dont knew if the Same Lense but Other Color has the Same Parts because i dont have these. And with that i can not check it. Manual: --------------IX Nikkor - 60-180mm Black: --------- On the IX Nikkor - 60-180mm Black you need Remove the inner Part which is Hold with 3 Screws. Then you need to cut the 3 Wings on the Printed Part where the Lense Move. You need to cut it like on the Picture to work correct. You need to make the 3 Holes for the 3 Original Screws to mount it All Electronic Function are there! The Autofoxus doesnt work beacause the Digital Cameras have not the Screw Drive for it. Focus must be make Manual but all Mode of the Camera Works. I dont knew if the Silver Version has the Same Parts. -------------IX Nikkor - 30-60mm Silver: ------------------------------------- On IX Nikkor - 30-60mm Silver you need to Remove the Metal Plate with the Circuit because it doesnt fit with. It convert the Objective to a full Manual which only work on Manual Mode. You can only let the Contact part for optical look or remove ist too. I make for both Version a Model. You need to drill 3 holes in the 3 blocks on the inner side then you can mount it with the 3 original Screws. The useless digital Port can replace with a Dandelion Chip. http://peleng8.com/af-lens-adapters/af-chip-dandelion-nikon-af-chip-dandelion-for-nikon.html With that the other modus can activate. But that is not testet yet from my Side. ------------IX Nikkor - 20-60mm Black and IX Nikkor - 24-70mm Black ------------------------------- These Lense have no seperate Middle Part and because that it must be cut. You need to remove the Upper Ring where the plastik sits like i show in the one Picture. But be carefull to let the red marked part on it because it has the holder of the Spring and that is needed. After cutting am make it smooth you mount it again and secure the Digital Port with its 2 Screws. Make this before you glue the Printed Part because it is then hard to place the Digital Port after glueing! Then you Glue the 3D Printed Part on the outer edge of the Cut Out and let it dry. --------------------------------------------------- 5.9.2021 Update the 3D Files of the 30-60 and the 60-180mm IX Nikkor --------------------------------------- 7.9.2021 Adding IX Nikkor - 20-60mm Black and IX Nikkor - 24-70mm Black parts and Manual -------------------------------------- 13.9.2021 Adding the New IX Nikkor 60-180mm Black Modell and the Manual