Ninebot Scooter ESx Front tire replacement tool

thingiverse

Hi, I created this adapter to replace the tire on a Ninebot scooter. After I tried for hours to do without, I created this simple part. I could not believe how simple it was to do it with this adapter. I simply manage to slide it on without to warm the tire and with a bit of dishwasher soap. Don't even try without it!! PS: After I create and printed, I was looking for some reference video to add and found out that somebody else had a similar idea a few month ago. See below his video and link to the part, he also needs credit for it. I printed on my smallest printer on PLA. The part largest diameter is about 151 mm . it took 6 hours, I adjusted the model to reduce it as it did not need all that mass. the pictures are of the V1 part. To remove the wheel, you dont need to detach the cables , simply remove the plastic protection, the mud protector, remove the 2x 18mm nuts (they are tide!!). pull a bit the cable so you can remove the wheel from the fork. unscrew the 5 security torx screws (use the right tool, with a hole in the center to allow the pin in). remove the hub from the center, so you can work freely. the magnet is strong so be careful. the old tire came off rather simply, the new one will be at least 15mm small in diameter. place the adapter you printed on the metal wheel, add some dishwasher soap and press the tire on it, it will fit on it and transfer on the metal wheel without too much issue. good luck Below some instructional video Youtube : https://www.youtube.com/watch?v=ZH6RM_SdRlw&t=345s thing:4191167