Nintendo Switch Joycon Mini-Grip

thingiverse

A standalone version of the center piece of the Joycon Grip. I made this to test out the rails for future designs. A few things to note: The Joycons do NOT lock into the rails. However, friction seems to hold them in place quite well. There are supports in place for a small overhang near the top of each rail. Not sure if they work too well, but remember to cut them off once the print finishes. I claim no responsibility if you screw up your Joycons with this print. So far, mine have seen no issues. Print Settings Printer: Monoprice Maker Select Rafts: Yes Supports: No Resolution: 0.2mm Infill: 20% Post-Printing You'll need to cut off the overhang supports near the tops of the rails. After that, the Joycons should be able to just slide right in.