Nintendo Switch Stand

thingiverse

Got me a Nintendo Switch for Christmas. I like the ability to use the Joy-Con and still play on the small screen, but I found that trying to charge the tablet while propping it up to play was a pain. I said to myself, "Someone should make a stand that can support this thing either on a flat surface or hanging over a chair or railing, with enough space under it that it's not resting on the charging cable." So I did. This is a marathon print; with 3 outer shells per layer and 25% infill for durability of the relatively thin walls, even at 0.2mm layer height, expect this to take 30+ hours. Also be sure your printer and slicer are calibrated for accurate prints; I left a *little* slack in all dimensions so the Switch slides right back out, but if your printer prints even a little wide it might be a tighter fit than it's supposed to be. However, if you're patient, the results are well worth it. Nintendo Switch not included.