No-Frills Samsung Galaxy Note 3 Case

thingiverse

Here's a no-frills variation of my Ultimate Note 3 case. This version ditches the cover, magnets and Sugru bumpers. . Here are the other variations: Ultimate (Magnets, Cover, Bumpers):http://www.thingiverse.com/thing:407517 No Bumpers (Magnets, Cover):http://www.thingiverse.com/thing:414865 No Cover (Sugru Bumpers, No Magnets):http://www.thingiverse.com/thing:424089 . I designed the case in two parts so that printers with small build areas (6"x6") such as the Printrbot Simple Metal could still print it. . This case is designed to fit the Note 3 WITHOUT the original back piece. You can still access the battery by sliding off the two sections. Instructions Print the Top and Bottom using support structures. I highly recommend InTheGarage's Slic3r settings here: http://www.camwatt.com/printrbot-simple-metal-slic3r-settings.html . Clean out the support structures using pliers. Fine tune with a Dremel and sandpaper. Be very careful around the openings. Keep testing until you achieve a snug fit. (Remove Note 3 back before sliding on case. This case doesn't use the original back.) I added a half millimeter extra of length to the edges where the Top and Bottom meet in order to get a gapless fit. You may need to sand these areas to achieve a perfect fit. . Remove the Note 3's original back piece and slide the case right over the exposed back. This case does not use the original back. You can easily access the battery and sd card by sliding off your new case's top and bottom. . Enjoy the case! Let me know if you have any suggestions for improvement.