No-tie balloon holder

thingiverse

Find it hard to tie balloons? Want balloons on a stick? Here's your solution! It is designed to print-flat for ease of printing and fold into position. The gap in the ring allows the end of the inflated balloon to pass through. The clip holds it in place and the balloon stays inflated with minimal effort and without a knot. The stick is designed in 10cm sections with joiners so that it can be printed on the smallest of beds. The complete file has enough pieces for a 30cm stick, in 3 sections. Print Settings Printer: Colido DIY 3d printer Rafts: No Supports: No Resolution: 0.2 Infill: 30% Notes: Printing in PLA my printer has great bed adhesion on blue painter's tape and doesn't require a brim, supports or a raft. You may need to add a brim to the holder if your adhesion is not so good.