Noctua NH-L9i in InWin Chopin Pro + 40x10mm noctua with Torus duct

thingiverse

basically slightly lower profile vs the original design by Kilrah as my intel 11th gen sat a little too high, also added an extra shroud for a 40x10mm noctua fan as well as an extraction to reduce heat soak around PSU built again from the ground up so no longer technically a remix but was heavily inspired by Kilrah's design theirs sits much tighter to the cpu fan which is great and much better if external temps are low, I personally just wanted more circulation of the air and to remove heat soak. v10 updated dimensions to fit loosely around cpu cooler instead of super tight, the side of the case will hold it on securely, I'll be updating this with a newer version once i get shrinkage and measurements accurate but this should hopefully do the job, updated location of 40x10mm fan studs and style to secure fan in place when pressed against the side mesh panel.