Nokia 5110 LCD case with pins (Taller)

thingiverse

The Nokia 5110 LCD was delivered with pins installed, so I had to modify the original case (http://www.thingiverse.com/thing:188205). It's easier just to mod the case rather than apply heat to the very thin PCB and remove the pins and solder. This new height will allow you to use a plug on the pins and slide the original back cover back on (maybe even some other electronics, like an LED) Back cover is located at source http://www.thingiverse.com/thing:188205 Instructions Print case top with .2mm height, 2 perimeters. install the nokia LCD and then install the slide back (can be found at http://www.thingiverse.com/thing:188205 - Did not modify it, so the original still fits.)