Norelco - First Shave - Holder/Charger Base

thingiverse

My teenager just got the OneBlade First Shave razor by Norelco this x-mas and right away it was obvious that he needed a holder. I drew this up in the morning and printed it one afternoon; probably took about 6-7 hours total print time, but of course your settings may vary. Note: I printed the base in PETG just because it's more likely to come in contact with water on the bathroom counter. Also, I used 45% infill in the base, and on the lower half of the top section because I wanted to give it some heft to prevent tipping... the rest of the top I printed at 10%. Lastly, the fit is pretty snug already, but of course you can apply a little glue to keep the two parts from separating when you remove the shaver. Enjoy!