Normandy/ Schwwin /Maillard Vintage FreeWheel Remover Tool for large diameter (NOT Park FR-4.2)

thingiverse

I was a man with a mission, didn't want to order a tool from ebay, or admit defeat. 8 revisions later and here we are. It got off the free wheel on my 1979 Schwinn Le Tour IV. As in the title, this is *not* a clone of the Park Tool FR-4.2, its for a larger 24 spline spec that Park no longer makes. You'd want to remove a certain amount of your rear axle, not farther than the keyed washer though *I used PLA at 100% infill*, but if your using something like ABS your infill could be dramatically lower **Important** in the STL, the tool is oriented vertically, your tool will break in an instant, if you print it vertically, it is imperative that you rotate it 90 degrees so that it lays flat length wise