NR200 15 mm Slim Fan Mounting Pins

prusaprinters

<p>Mount slim fans on top of Cooler Master NR200P case.&nbsp;</p><p>I wanted my PSU to hang higher inside the case to help with cable management, however that caused the power plug to collide with the stock 25 mm thick fans. So I made this to install slim Noctua fans (15 mm).</p><p>Two versions are included:</p><ul><li><strong>Pin_Screw.stl</strong> replaces the stock pins - use those to install stock grills with the screws shipped with the case; those will allow for about 5 mm more clearance than the original pins,</li><li><strong>Pin_NoScrew.stl</strong> sits practically flush with the fan body; should give you about 10 mm more clearance compared to the original mounting hardware. Spinning fan blades are sharp - watch your fingers ;-)</li></ul><p>My top fans pull the hot air out from the case, so I'd recommend printing this using PETG or similar material that won't soften as much under higher temperature. <i>I printed prototype of the NoScrew version in PLA and it didn't seem too damaged after a few weeks inside the case, but you know, better safe than sorry!</i></p>