Octopi Raspberry Pi 3 B+ Holder for Anycubic Mega S w/ camera mount

thingiverse

This is a great design, it fit my Anycubic Mega S perfectly. I decided I wanted a 40mm fan and the ability to future proof access the GPIOs for things like the Emergency Stop and/or relay options for PSU control. I kept all the original side cut outs. However, I opted to use the front cut-out for the ribbon as it gave me the ability to move and adjust the camera easier without damaging it. Adding the fan can cause unwanted vibrations on the camera. Built an arm extension to mitigate some of this and add more freedom and length to it. It's better if you add rubber pad to your fan to get rid of any vibrations. Camera Ribbon Extensions: https://www.amazon.com/dp/B089LM5D1T?psc=1&ref=ppx_yo2_dt_b_product_details Remixed Front Cover with Fan Mount: https://www.thingiverse.com/thing:1815268 Fan Grills: https://www.thingiverse.com/thing:4837562 (Original Summary of the Holder) https://www.thingiverse.com/thing:4441076 presented a thumb screw to replace the wing nut on the front-left corner of the BIBO bed. It is too wide for the other two positions. I have created a smaller version to fit the right-front corner and the back-center. A M3-.50 nut is required.